New ELOFIT range of valves with DN125 port diameter, PE100-RC SDR11 PN16 MOP10. The valve in the photo is code 12EVS225125 (reduced bore). The same valve body can be used to produce 12EVS160 and 12EVS180 (full bore) versions and 12EVS200125, 12EVs225125 and 12EVS250125 (reduced bore). ELOFIT is a High Density Polyethylene PE100 system of electrofusion and spigot fittings and special components for the conveyance of water and gas under pressure. ELOFIT fittings are manufactured by injection moulding of High Density Polyethylene and achieve the highest standards as regards corrosion resistance, resistance to stray currents, impact resistance, resistance to chemical agents, abrasion resistance, resistance to micro-organisms, reliability for more than 50 years, non-toxicity. ELOFIT is suitable for the conveyance and distribution of drinking water and alimentary fluids, fuel and inert gases and for water treatment plants, centralised irrigation and sewage systems, fire protection systems and pipe relining. The ELOFIT system is mostly assembled through the electrofusion process. On the inside, the fitting houses electrical resistors connected to the outside cable terminals. When current moves through them, these resistors generate the heat needed to melt polyethylene. Energy is transmitted directly and exclusively to the surface where pipe and fitting come into contact with each other, producing heat welding. The main feature of ELOFIT fittings is the high quality and reliability of the welding. When it cools down, the connection is even, strong, safe and reliable. ELOFIT fittings boast the most renowned international certifications.